If you’re really worried about power use, you could switch to an itx motherboard with an soc laptop chip in it.

Visually lossless means I couldn’t tell an image difference even when pixel peeping with imgsli. Good enough means I couldn’t tell a difference in video, but could occasionally see a compression artifact in imgsli.

The VMAF results are purely objective measurements. You can read more about it here; https://en.wikipedia.org/wiki/Video_Multimethod_Assessment_Fusion

I consider the ‘good enough’ level to be, if I didn’t pixel peep, I couldn’t tell the difference. The visually lossless levels were the first crf levels where I couldn’t tell a quality difference even when pixel peeping with imgsli. I also included VAMF results, which say that the quality loss levels are all the same at a pixel level.

I know that av1, x264, and x265 all have different ways of compressing video. Obviously, the whole point of this was to get a better idea of what that actually looked like. Everything on the visually lossless section is completely indistinguishable to my eyes, and everything on the good enough section has very minor bits of compression only noticed when i’m looking for it in a still image. This does not require the same codec to compare and contrast with.

Frankly, for anything other than real-time encoding, I don’t actually consider encoding time to be a huge deal. None of my encodes were slower than 3fps on my 5800x3d, which is plenty for running on my media server as overnight job. For real-time encoding, I would just grab a Intel Arc card, and redo the whole thing since the bitrates will be different anyways.

From my blogpost, i’m using the following command to encode the video;

ffmpeg -i source.2160p.mkv
-map 0:v:0
-map -0:a -map -0:s -map_metadata -1
-c:v libsvtav1
-preset 3
-vf scale=w=1920:-2
-crf 23
dest.1080p.av1.mkv

Sure, but that is a choice that couldn’t be made without first checking how much space is saved by switching codecs. This helps with making that decision, but i’m well aware it is only part of the information needed.

Stolen. Thank you.

I did try to format the table here better. I used code blocks the first time, and it ended up being even uglier. After about four edit attempts i kinda just gave up. Tables don’t seem to exist as far as I can tell either.

Your experience with x264 just about matches up with mine. As long as I don’t pixel peep, crf 24 does a pretty great job of conveying the information. It also does a pretty great job of working with just about everything compatibility-wise. I don’t expect it to go away any time soon specifically because of that.

AV1 is super neat in that we can buy hardware accelerated encoding for it for really cheap using the Intel Arc video cards, and can be decoded by their latest CPU generation. It makes for a great choice for something like security camera footage where playback compatibility is good enough (you can play it in a modern pc), hardware encoding works with a 200$ card, and you save a lot of money using the video card instead of buying extra storage space.

Oh my god i love that.

Gotta be careful with osmc. It has so much choice that breaking is entirely possible to do accidentally. I absolutely love my little 4k box.

And it wouldn’t have gpio, would require at least a square foot of floor/desk space, and it would cost more to run. Price. Size. Gpio. Nobody is running their remote controlled car with a cabled desktop sat on it.

You’re funny. That makes the total 77$. Still not the 100$ + required accessories that a desktop needs.

Oh his point stands,

No it doesn’t. The power supply is 8$ and the case is 10$, from the official store. That’s 72$. Stop lying.

Not really. It’s made to run headless, and isn’t always used for compute tasks. I use mine for running servos. But accessories for the desktop are also not included, so your point doesnt stand regardless.

100$ isn’t cheaper than 55$. That’s 200% more than the pi. If someone is looking for a pi because of the price, a 100$ computer isn’t an option.

Is it $60 or less? Everytime one of these alternative boards with an assload of more features pops up, nobody bothers to mention the price. Obviously we could spend more money to get more features, that’s what spending more money does. You can’t replace something without actually offering an alternative. The pi’s biggest selling point was that it was cheaper than a steak dinner. If you dont match or beat that, you aren’t actually competing with the pi.

Technically yes, but actually no. CEC is horrible and it’s considered a genuine miracle when someone ever gets it working.

I can only assume they don’t drop the hammer because they can take a cut instead.

you have way too much faith in a government agencies ability to see, understand, and act on a situation.

The entire purpose of my inquiry is to not sit here and waste each others’ time going back and forth for hours on end over text trying to figure it out. It’s for us to be able to have a discussion and so that you can see what I’m doing as I’m doing it.

I only post on forums because if everybody used discord and other non-searchable communication mediums, the internet would be a complete failure, or about as available as peoples secret mushroom spots. I promise you that the issues you face are not original. Everybody else who comes across this thread looking for a good place to start is going to be pissed because there’s only one or two listed, when there could have been an entire thread full of good places to start, with commentary about specific tutorials and why they suck or what parts a new person could get stuck on.

These forums are not just for you to use as a dump to vaguepost and hope someone will spend several hours of their life cheering you on while you figure out how to do stuff. They are for everyone in the thread, and everyone who comes after while looking for similar solutions. Trying to take whatever support you end up getting away from everyone who comes after you is called pulling up the ladder after yourself, and is the exact opposite of why forums exist in the first place.

If people had actually been rude when you asked a basic question, it would be different. But it isn’t. You’re not trying to engage with the way this forums actually works and it really shows. As far as I can see, most everyone here is trying to help. You just don’t want the great help that is being offered. You want an unpaid private tutor who will cheer you on and sometimes give you a tip to make things easier, while you avoid doing things like reading the manual, looking through tutorials, or heaven forbid, googling what aomething is.

We know. What you’re asking for is the wrong to thing to ask for, here in these forums. Aint nobody got time for walking a strqnger through thw entire install process of five or eight different self hosting programs. My own personal process has taken several months and is still ongoing.

You said that you have an issue with some software (you did not even bother to specify which)

Actually I did.

You didn’t. You very specifically asked for someone to commit to helping you personally with nonspecific issues rather than asking for help from a general group for a specific issue (which would have been more likely to get help).

posted what I’m trying to achieve

I did.

Maybe, but what youre trying to achieve isn’t getting a helpful answer for a specific question. You’re trying to get someone to commit to helping you for an unspecified amount of time with an unspecified amount of problems. CriticalMass is telling you that is a bad way of obtaining help for a problem anywhere except in school and a job classroom. This is neither of those.

why I’m unable to do it so far

Did that also.

Maybe try reading more carefully before calling someone out for some bullshit.

No, he read your post just fine. You just don’t like the answers you’re getting. Asking for help with a specific thing is exactly what these forums are for. Asking for help getting started is even okay. We love sharing a good tutorial for getting a new user started with a specific software.

You aren’t doing any of those things. You’re asking for someone to spend hours of their time, in a call with you, to walk you through a process that has hundreds of online tutorials already out there. You’re also getting mad when people tell you that what you’re after is not what this discussion forum is for.

Maybe try reading more carefully before calling someone out for some bullshit.